Morbark 48" Chip Pak

80's chip pak in good condition, complete with 5X5 shaker, cyclone, blower 100hp drive, 15hp single chute blower, 5hp fines blower, vibrating conveyor...
read more

Progress 60" Chipper

3-knife (was built for 6), needs new faceplates to be a 6-knife carbide counter knives and anvils 100hp motor side feed, bottom discharge includes chipper, motor, and knives...
read more

Morbark 58" Chipper

Morbark 58 inch chipper, 3-knife (was built for 6, new faceplate put in for 3-knife), new faceplate and bellypan put in 3 months before taken out of service in 2008, side infeed, top discharge
read more

Fulghum 60" Chipper, 8-knife

Fulghum 60 inch chipper, 8-knife, right hand, bottom discharge, never ran!, Model: 60-8K-HFBD, not to exceed 700 RPM, located in Southeast

Progress 72" Chipper

Progress 72 inch chipper, 8-knife, completely rebuilt, less than 40 hours on rebuild, very nice condition
read more

Fulghum 75/84" chippers, 4-knife

4-knife one of the chippers is ready to use, installed in 1980 and primarily used for chipping slabs off of the mill with some round wood. chip size target is 3/4".
read more

Precision 48" chipper, 3-knife

3-knife chipper, location: Southeast US
read more

Precision 58" Chip Pak, 6-knife SOLD

6-knife, 7X7 Precision screen, 18” Vibratory Conveyor w/Alert Detection System, Metal Detector, sub base frame, 150HP motor cyclone with piping
read more